|
|
| |
Due to abuse - forum is closed and in archive mode only
Bruce
|
 Posted: 01/08/2005 at 12:15 PM Post subject: TB 2000 Pickup height/setup |
link
|
|
Just wondering if anyone knew if the pickup height could be adjusted on the TB 2000's...I really dislike fret buzz, but I'm at the point where lowering the action would give me a ton of buzz, but I'm not getting the output I expected from the low end....can anyone help?? Thanks!
|
|
Back to top
|
|
|
|
Disclosure: Any links to eBay or Amazon.com are affiliate links. Affiliate links may provide commission payments to the site based on purchases.
|
|
|
|
wade
|
| Posted: 01/11/2005 at 6:04 AM Post subject: RE:TB 2000 Pickup height/setup |
link
|
|
The only way I know of raising the pickup high on a Bean Bass is to unscrew the two bolts on the back that hold the pickup in place, carefully lift the pickup out of its cavity without undoing the wiring and then slip a piece of thin metal or card underneath on the aluminium recess, slot the pickup back in and screw the bolts back up. Keep doing this until you get to the required pickup height needed.
|
|
Back to top
|
|
|
|
|
|
|
Due to abuse - forum is closed and in archive mode only
|
|
|
