|

|
Due to abuse - forum is closed and in archive mode only
jbb
|
Posted: 03/05/2005 at 1:03 PM Post subject: Removing the Body from a TB2000 |
link
|
|
Hello, Does anyone know how to remove the body from the neck on a TB2000? Thanks.
|
|
Back to top

|
|

|
Disclosure: Any links to eBay or Amazon.com are affiliate links. Affiliate links may provide commission payments to the site based on purchases.
|
|

|
wade
|
Posted: 03/08/2005 at 2:32 PM Post subject: RE:Removing the Body from a TB2000 |
link
|
|
It's been a long time since I have done it but if I remember right you will have to un-solider the pickup wires at the pots, then unscrew the pickup bolts at the back of the body and pull the pickups out. Inside each pickup cavity are two wood screws, once these are unscrewed the neck receiver just slides out of the body.
|
|
Back to top

|
|

|
Chris Hall
Joined: 01 Jun 2001
Posts: 132
|
Posted: 03/11/2005 at 7:40 AM Post subject: RE:Removing the Body from a TB2000 |
link
|
|
I took the body off of my TB2000 one day when I was bored. Didn't have to unsolder anything. Just unscrewed the neck pickup, took out the wood screws that are under it, took the saddle pieces off the bridge, took out the 2 screws, and the neck came right out.
Apparently the bodies were glued on to the necks, but I don't remember seeing any trace of glue in there...
|
|
Back to top

|
|

|
|
|
|
Due to abuse - forum is closed and in archive mode only
|
|
|